Operational linear transponder satellites have dwindled to only two: VO-52 and AO-7. The latter, now 37 years old, spends approximately half its operating time on the V/A transponder, or what we used to call Mode A: 145.85-145.95 MHz uplink, 29.4-29.5 MHz downlink.
Unfortunately, activiity on the V/A transponder is quite low compared with what it was in the 1970s. Today, as then, much of this problem can be attributed to the V/A transponder's relatively weak downlink signal. In the 1970s, however, many users were able to solve this problem and work DX through this transponder out to nearly 8,000 km.
How did they do it? As one of those 1970s users, I'll tell you: low-noise preamplifiers and good 10-meter antennas. In 2011, most modern radios have enough sensitivity that an external 29 MHz preamplifier should not be required. That leaves the antenna. Most satellite users wouldn't think of operating Mode U/V without good antennas. The 29 MHz band is no different.
As any successful 1970s Mode A user can attest, a good 10-meter beam is by far the best choice. For best results, it should be pointed at the horizon, not elevated. Why? For most users at temperate zone latitudes, AO-7's elevation angle will be 10 degrees or less about half the time it is in range, and 30 degrees or more only about 10% of the time. During that 10%, the inverse-square law of distance will keep signals strong despite AO-7 being outside the beam's major lobe..
As in HF operation, the beam should be mounted as high above ground as possible. My friend Ben, W2BXA (now SK), with his beam at 20 meters, was able[ to work stations up to 300 km farther away than I could with mine at only 10 meters. That is a large part of the reason why Ben held Satellite DXCC No. 1 while mine is No. 13.
If you cannot put up a beam, a rotary dipole is perhaps the next best choice, again mounted as high as possible. If you cannot do that either, try a ground plane antenna, mounted so as to be clear of all obstructions. No matter what your specific circumstances, put up the best 10-meter antenna you can.
Let's use and enjoy BOTH transponders of AO-7!
73 Ray W2RS
Is anyone adjusting elevation on the 10 meter side? ________________________________________ From: amsat-bb-bounces@amsat.org [amsat-bb-bounces@amsat.org] on behalf of Rsoifer@aol.com [Rsoifer@aol.com] Sent: 08 December 2011 14:14 To: amsat-bb@amsat.org Subject: [amsat-bb] AO-7 V/A Transponder (Mode A)
Operational linear transponder satellites have dwindled to only two: VO-52 and AO-7. The latter, now 37 years old, spends approximately half its operating time on the V/A transponder, or what we used to call Mode A: 145.85-145.95 MHz uplink, 29.4-29.5 MHz downlink.
Unfortunately, activiity on the V/A transponder is quite low compared with what it was in the 1970s. Today, as then, much of this problem can be attributed to the V/A transponder's relatively weak downlink signal. In the 1970s, however, many users were able to solve this problem and work DX through this transponder out to nearly 8,000 km.
How did they do it? As one of those 1970s users, I'll tell you: low-noise preamplifiers and good 10-meter antennas. In 2011, most modern radios have enough sensitivity that an external 29 MHz preamplifier should not be required. That leaves the antenna. Most satellite users wouldn't think of operating Mode U/V without good antennas. The 29 MHz band is no different.
As any successful 1970s Mode A user can attest, a good 10-meter beam is by far the best choice. For best results, it should be pointed at the horizon, not elevated. Why? For most users at temperate zone latitudes, AO-7's elevation angle will be 10 degrees or less about half the time it is in range, and 30 degrees or more only about 10% of the time. During that 10%, the inverse-square law of distance will keep signals strong despite AO-7 being outside the beam's major lobe..
As in HF operation, the beam should be mounted as high above ground as possible. My friend Ben, W2BXA (now SK), with his beam at 20 meters, was able[ to work stations up to 300 km farther away than I could with mine at only 10 meters. That is a large part of the reason why Ben held Satellite DXCC No. 1 while mine is No. 13.
If you cannot put up a beam, a rotary dipole is perhaps the next best choice, again mounted as high as possible. If you cannot do that either, try a ground plane antenna, mounted so as to be clear of all obstructions. No matter what your specific circumstances, put up the best 10-meter antenna you can.
Let's use and enjoy BOTH transponders of AO-7!
73 Ray W2RS _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
participants (2)
-
John Floyd -
Rsoifer＠aol.com