Any body got the Doppler.Sqf file for RS-44? TNX, Michael – n8iup
Hi Michael,
Try this:
RS-44,435640,145965,USB,LSB,REV,0,0, +/-30kHz xponder
73, Mark N8MH
On Tue, May 26, 2020 at 12:17 PM Michael A. Foster via AMSAT-BB < amsat-bb@amsat.org> wrote:
Any body got the Doppler.Sqf file for RS-44? TNX, Michael – n8iup _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb
Trying to get SATPC32 up and running with the 9100. Most problems I have solved, but would have been a lot easier if the error messages were in English.
Trying to get the WINAOS to work. I have changed the satellite groups to 3 groups one of which is standard. So when I run the AOS it still has all the other sat groups and sat settings that were there on install. It also does not keep my grid sq and keeps altering my log/lats. In reading some of the help files I see where the files do not have the right info in them either.
Does one have to go into each .aos file and change the settings. Cant seem to find a help section for this part.
I have the rotor and rig talking fine, just trying to get some frills stuff working now.
Have you registered it? While otherwise fully functional as a trial version, SatPC32 only retains your settings if registered.
Also, the satellites you select in WinAOS are separate from those selected in the SatPC32 main program.
George, KA3HSW
-----Original Message----- From: AMSAT-BB [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Bill Booth via AMSAT-BB Sent: Tuesday, May 26, 2020 11:10 PM To: amsat-bb@amsat.org Subject: [amsat-bb] WINAOS in SATPC32
Trying to get SATPC32 up and running with the 9100. Most problems I have solved, but would have been a lot easier if the error messages were in English.
Trying to get the WINAOS to work. I have changed the satellite groups to 3 groups one of which is standard. So when I run the AOS it still has all the other sat groups and sat settings that were there on install. It also does not keep my grid sq and keeps altering my log/lats. In reading some of the help files I see where the files do not have the right info in them either.
Does one have to go into each .aos file and change the settings. Cant seem to find a help section for this part.
I have the rotor and rig talking fine, just trying to get some frills stuff working now.
participants (4)
-
Bill Booth -
George Henry -
Mark L. Hammond -
Michael A. Foster