17 Dec
2008
17 Dec
'08
4:28 p.m.
HI, Peter The draw of the data socket on Icom 910 manual is for the female socket (on the radio) . The male socket is a mirror of this draw check up this first.!! Pins are:- Pin 4 for 9k6 Pin 5 for 1k2 Pin 2 grounds Pin 1 data in Pin 3 PTT Ground connect to the base of the audio plug and data out to the tip of the plug. On the back of the radio there were two mini sockets one for main band and other for sub make sure you select the right one. The ACC pins configuration can be programmed through setup mode. Make sure the correct baud selected. Checkup and test your PC soundcard input and out put. I hope this will help! seasons greating. Nader , st2nh
www.st2nh.com
5850
Age (days ago)
5850
Last active (days ago)
0 comments
1 participants
participants (1)
-
nader omer