Hi to all.

Yesterday I was evaluating the construction of a small antenna for portable use on top of the Baofeng UV-5R... at the end I finished with two choices CJU vs moxon for 70cm handheld

After some modeling I choose the moxon over the CJU because: - Smaller - Less wire - Less weight - Less stress for the connector - Just ~0.6 dB down vs the CJU - By far better F/B ratio

After completion of the first "prototype"...

I successfully heard the CW beacon of Jugnu, CO-57, CO-58, PRISM and others.

The fire test will be tonight on SO-50, I know now I will copy ok, but the challenge is eliminate the desense of having two yaguis on a cross boom.

I will test the moxon handheld on RX (UHF) and a Jpole for the 2m uplink with 5W of a handheld.

I have not measured the SWR of the moxon, but with the simulation the measures are not "that critical" for getting a less than 1:2 of SWR over the entire 70cm band (1:3 bandwidth is about 16 Mhz)

The moxon "experiment" is just ~25 cm width and ~15 cm height (may be smaller also, the minimal height is ~10cm + connector) over the Baofeng UV-5R, there is no much stress on the connector.

I used a SMA to BNC adapter (the kind with a rim to fit tight to the radio body) and then a clamp on BNC (male) with a bronze tube as coaxial shield/boom of the antenna.

Wish me luck with the desense problem...

73