I decided to swap out my ft-847 and TS2000. Te 847 was working fine along with my Flex5000A, both being controlled by SatPC32. Aside from redefining the radio 2 parameters in satpc's setup window,image no changes. I tried several different cat baud rates bot on the ts2k and saps, but without success. I then bypassed my keyspan 4port serial to USB hub and used a separate serial to USB converter (another brand) wired from the radio to by USB powered hub. Still no cat control of the radio when satpc32 starts. Anyone have any suggestion?
Rick
Sent from my iPad http://RickLawn.com
Rick, Quick check. Chain one serial to another and watch with your favorite terminal program the output of satpc32. Not that I care, as long as it's working. could have some bad hardware. cable, connector, etc.
While you're in there, you should check that the parameters agree with what's in the panel for satpc32. gl de Norm n3ykf On Wed, Dec 5, 2012 at 4:59 PM, Lawn, Richard RLawn@uarts.edu wrote:
I decided to swap out my ft-847 and TS2000. Te 847 was working fine along with my Flex5000A, both being controlled by SatPC32. Aside from redefining the radio 2 parameters in satpc's setup window,image no changes. I tried several different cat baud rates bot on the ts2k and saps, but without success. I then bypassed my keyspan 4port serial to USB hub and used a separate serial to USB converter (another brand) wired from the radio to by USB powered hub. Still no cat control of the radio when satpc32 starts. Anyone have any suggestion?
Rick
Sent from my iPad http://RickLawn.com
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
participants (2)
-
Lawn, Richard -
Lizeth Norman