Looking for someone who is Intelligent, Ambitious, Not Too Old, and Dedicated.
Hi,
The fact that you opened this message means you are all of the things mentioned in the subject line and probably even good looking.
This fellow has come up with what I believe is the first really good portable rotor controller (even better than mine !). He is planning on releasing the plans to the public. Fabrication was done with a 3D printer. It is a work of art. It is not some pie in the sky all talk and no action thing we are all used to hearing about.
http://www.mobypicture.com/user/MeltdownCore/view/18165109
Here is a clip from a recent email he sent to me.
There are many people out there that have 3d printers in these days. When i
designed the rotor i wanted to make sure that most parts come out the 3d printer so all you have to do is to get some easy to get parts and start building. I absolutely hate it when i want to build something and when i check the partslist there are exotic parts that you only get from russia or korea.
I am sure that most "makers" have every part at home except the big ball bearing.
Perhaps there is someone or a group out there who would be interested in taking this project on for possible sales that could benefit AMSAT.
F.A.Q.
Q: Have you seen the rotor article in QST ? A: Yes and I believe this is much better.
Q: What about the AMSAT board ? A: It appears that they *might* be open to marketing it as they do with the LVB Tracker and pre-amp.
Q: Why don't you just leave us alone and do it yourself ? A: I am old.
73 W9KE Tom Doyle
Quoting Thomas Doyle who wrote on Sun 2015-06-07 at 11:46:
The fact that you opened this message means you are all of the things mentioned in the subject line and probably even good looking.
No, it was just the next message in my inbox.
But besides that bit of bad marketing:
This fellow has come up with what I believe is the first really good portable rotor controller (even better than mine !). He is planning on releasing the plans to the public. Fabrication was done with a 3D printer. It is a work of art. It is not some pie in the sky all talk and no action thing we are all used to hearing about.
This looks good. This seems to be moving an Elk Antenna with little problem with for a sat antenna 'high' speeds so it may move an Arrow Antenna or even heavier stuff (given a good center of gravity) at 'normal' speeds with little problem.
I must say it also looks more solid than SatNOGS, to be honest. https://satnogs.org/
It will be in roughly the same 'market' : an antenna rotator that is not too expensive, doable to build, can be controlled from tracking software such as gpredict and isn't weather proof but can be set up on a dry day on a tripod easily.
Perhaps there is someone or a group out there who would be interested in taking this project on for possible sales that could benefit AMSAT.
There are people who can take the bill of materials, the stl files, the software and can build it themselves. Or take the stl files to a 3D printer service or makerspace.
There are people who want to buy the parts sorted with instructions and will build it.
But there are lots of steps between 'it moves!!!' and 'it is something someone else should be able to duplicate' and even more steps before 'someone can sell the parts and instructions for someone to rebuild it'.
Keep us posted!
Koos van den Hout
participants (2)
-
Koos van den Hout -
Thomas Doyle