Hi Kevin,

Thanks for the report!

Although we have not had any other similar reports, I have also noticed something similar happening and the matter was discussed last evening during our FUNcube team Skype chat.

If you are able to keep a note of exactly how the two dashboards are set up, which was started first, where the frequency limit "blinds" are, what the centre frequency is - or anything else that will enable our development team to identify the cause of the oddity then that would be very helpful!.

Many thanks

Graham G3VZV

-----Original Message----- From: kevin schuchmann Sent: Monday, March 13, 2017 6:00 AM To: [email protected] Subject: [amsat-bb] EO-88/AO-73 dashboard oddity

I have noticed while running the EO-88 dashboard that if it first decodes a AO-73 pass and then EO-88 comes up right after then the dashboard ignores the signal for a long time, if I catch it doing it and close and then reopen the program then it instantly locks up, does the program keep looking for the sat it was decoding for awhile? anyone else notice this behavior?

I have also seen the FUNcube-1 dashboard do the same thing, decode one sat fine and then ignore the next one if it is right behind the first one.

73 Kevin WA6FWF

_______________________________________________ Sent via [email protected]. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb