In your original post, you said " I have no decoding packets whatsoever either
from ARISS or terrestrial on 144.390." Since RX is in fact working, the most
likely transmission problem with the Flex is that compared with traditional
rigs, there is considerable latency, or delay, between the audio input and
transmission. The result is that the transmitter cuts off before the full
packet is sent. Fortunately there is a parameter, TXtail, which will keep the
transmitter keyed for a period after the audio is sent. Somewhere in
Soundmodem, probably the Modem tab, IIRC. Try setting it for 500 ms or so,
and see if that helps. It solved my problem. After you get it working, you
can cut that back a bit, if desired. How much is a complicated function of
sampling rates, buffer sizes, etc.
Another issue is deviation. Too much is much worse than too little. I find
that setting VAC at -14 gives me 3 KHz deviation.
<From: Richard Lawn [mailto:[email protected]
<Sent: Tuesday, February 28, 2017 17:01 PM
<To: Alan Biddle <wa4sca(a)gmail.com>
<Subject: RE:ARISS Packet
<Decoding for me either at ARISS downlink freq or 144.390 isn't the problem. I
<seem to have no luck getting any confirmation packets back at 144.390 and I
<should think using WIDE I should at least see my own packets echoed back.