Hello Nayer,

I have not seen any other's response, so, here is mine.... Performance verification, one step at a time.

I verify performance and calibrate all scales before the positioners are put on the tower.

Start off reading the instruction manual for operation and maintenance. Replace any corroding hardware as needed, one piece at a time. Be sure all hardware is torqued properly and NOT loose. Do not hesitate to grease all threads with a tenacious axle grease, all aseembly bolts/screws and clamps. The grease allows you to take stuff apart 10 years later.

Before connecting anything, measure the resistance of the AZ and EL positioner internal position indicating potentiometer.

Do the numbers agree with the manual ?

Measure the motor winding resistances. Do both the AZ and the EL positioners. Document findings. Is the manual in agreement ?

Determine how much rotator control cable length you will need Sketch out a wiring diagram and document the wire color scheme you will be using. (My 8 conductor rotator control cable uses 8 different colors.)

Assemble the cable to the AZ and EL rotator with the actual length of rotator control cables to be used. Do not add antennas at this time. Orient the AZ and EL positioners as they would be used.

Measure the resistance of the AZ and EL motor windings, with the cable attached, at the controller end of the cable. Measure the resistance of the indicator potentiometer for both AZ and EL. Document your findings. Are readings reasonable ? Correct any problem.

Wire up the control cables to the controller and add a means of measuring the AC current to the controller.

Apply AC power to the controller and note the AC current draw. Exercise the AZ rotator, verify that the AZ rotator turns clockwise or counterclockwise as activated. Note the AC current when the AZ rotator is turning. AC current should be the same CW or CCW rotation. Is the azimuth indicator going thru it's entire display range ? Calibrate the AZ display according to the manual. Verify position range after any adjustments. Some AZ controllers only go 360 degrees +/- a few degrees , some go more. Park the AZ positioner at one end of its rotation. I call this NORTH. (0.0 degrees true north)

Exercise the EL posioner, Calibrate the display as indicated in the manual. Not the mechanical noise to the AZ or EL motor turning. Measure AC current to the positioner as the EL motor is turning max speed. Document. Park the EL positoner at 0.0 degrees elevation.

Measure the AC or DC current from the controller to the AZ and EL positioner, document. Measure the voltage at the controller output, no load and full speed positioner load Disassemble and reassemble on the tower. Add the antennas Slip the mast for 0 degrees true north. Torque down the mast clamps Slip the boom for 0 degrees elevation. Torque down the boom clamps.

Exercise the AZ and EL over its full range. Measure AC current to the controller with antenna loading. Measure the AC or DC current from the controller to the positioner, with antenna loading. Document findings.

Play satellite.....

I hope this helps

Stan, w1LE Cape Cod FN41sr

On 11/8/2010 7:37 AM, N. Mahdinejad wrote:

Dear all.

Thanks for Bob W7LRD and Greg D for answering to my last question.

Is there any standard document or other for test antenna rotator? Some functional and environmental tests.

If anyone is familiar with these tests, please send me a link to read or download some useful documents.

Any help would be gratefully appreciated.

Best regards.

Nayer Mahdinejad. _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb