Top three pics are of a G-5400 resurrected. Portable in FM28lo

https://www.flickr.com/photos/n3ykf/

K3NG arduino controlled rotator with a gps rx and four extra relays controlled via serial. Total cost of a basic controller is about $30. As built? Around 100$

Tripod, antennas, preamps, radios, rotator and batteries not included.

Norm n3ykf

On Wed, Jun 8, 2016 at 12:57 PM, Pedro Converso [email protected] wrote:

Hi Frank,

Try http://amsat.org.ar/pass.htm , along with wispDDE driver could control Rotor as well as Dopplers.

Wishing success in installing and using your Rotor.

73, lu7abf, Pedro

On Wed, Jun 8, 2016 at 11:35 AM, Franklyn A. Ballentine, Jr [email protected] wrote:

...

Hi All,

I just picked up a Yaesu G5400B Az\El from another ham who was using it for EME. This is my first rotator, so any hints and tips would be greatly appreciated. I have noticed some sticking in the control box, so I'm guessing DeOxit is in my future. The goal is to get this under computer control. What's the best way of doing this?

Thanks, Frank B kb1qzh _______________________________________________ Sent via [email protected]. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb

---

Sent via [email protected]. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb