Hi again Guys,

Success! Thanks to all the replies I got with advice on how to remove the surface mount IC. I applied heat from the blow side of my solder station and it popped off after a little bit with a little help at one corner. I had lifted all 22 leads from their pads first so I wouldn't damage a pad when it popped off. There were four small round glue spots down the middle of the bottom of the IC. Pads 1 and 22 were oversize so it was easy to spot the replacement IC with a good blob of solder on those two pads before I started soldering down the other pins.

Thanks again for all the suggestions.