Whoops! Carl is correct.

"C+" should be on during the entire procedure so that SatPC32 is controlling the radio. Use "CW+" and "CW-" to switch from SSB to CW and back. That's one of the problems with doing this from memory, at least from *my* memory. ;-)

Thanks Carl!

73, Steve N9IP --

-----Original Message----- From: amsat-bb-bounces@amsat.org [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Carl Rimmer W8KRF Sent: Friday, September 23, 2011 4:42 PM To: amsat-bb@amsat.org Subject: [amsat-bb] SSB, SatPC32 and Doppler (was Two Questions)

Steve N9IP did a very good job of explaining how to set up for VO-52 and other transponder type sats. I have the TS-2000 and use SatPC32 with it with great success on the FM birds especially ARISSat-1. There is one clarification I would like to make to Steve's SOP. The "C+" and "C-" should be "CW+" and "CW-". We don't want confusion between that and turning CAT control on and off.

I used HRD Sat Track for years and always had problems with the Doppler correction. This has not been the case with SatPC32. I love it and will continue to use it for all my sat work. I am hoping to get more active since I will be installing two mast mounted pre-amps tomorrow. The anticipation is driving me nuts. I hope I am not let down.

73,