Mark,

Look under Radio Setup: The top dropdown box normally says Model. However, you can select Baud Rate. The FT-847 will work fine at 57600 baud with SatPC32.

73,

Alan WA4SCA

<-----Original Message----- <From: AMSAT-BB [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Mark <Coulthurst <Sent: Monday, January 07, 2019 13:53 PM <To: AMSAT-BB@amsat.org <Subject: [amsat-bb] FT-837 port config question < <Hi <Im new to the BB list so i hope this has been done correctly.... < <I have a Yaesu FT847. I have satpc32 that will connect happily to the radio <and control everything as required but this only works if i set the radio <CAT menu to 9600. < <Everything esle i run works at the 57600 CAT Rate and i have to change the <radio every time to 9600 CAT rate to use satpc32. < <My question is this: <i presume there is a file that has the radio CAT configurations within the <sodtware. I would like to know if this is accessable and if i can overide <the 9600 current setting within satpc32 to change it to 57600? < <Thanks in advance < <M1AEC <_______________________________________________ <Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available <to all interested persons worldwide without requiring membership. Opinions <expressed <are solely those of the author, and do not reflect the official views of AMSAT- <NA. <Not an AMSAT-NA member? Join now to support the amateur satellite <program! <Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb