Congrats on the Gulf-Alpha. I had one and loved it. Built battleship strong, computer optimized, using a Tee-match. Nothing flimsy about it! The only thing I did stupid was sell it when I had to move.
If anyone wants to part with one, let me know!
73, Joe kk0sd
-----Original Message----- From: AMSAT-BB [email protected] On Behalf Of Gregory Beat via AMSAT-BB Sent: Saturday, February 29, 2020 9:47 AM To: [email protected]; [email protected] Subject: Re: [amsat-bb] Gulf Alpha Antenna Manual
In November 2015, Tim Chapman, KB7MDF owner of Arrow Antennas purchased the VHF, UHF and Satellite product lines from Pete, owner of Gulf Alpha Antennas. http://www.arrowantennas.com/ga.html
Arrow Antennas may have kept (or posted) documentation for those earlier Gulf Alpha Antennas. http://www.arrowantennas.com/
greg, w9gb == Assembly and Tuning Procedures for 2 meter – 70 Cm Dual band Circular Polarized Satellite Yagi 1. Unpack and separate all parts, UHF, VHF element rods, retaining nuts for the element rods, T matches etc.
2. Assemble the two boom sections, be certain to match up the V half’s which are on the ends of each boom section. Usually this is the only way they can go together. Sections are marked VHF, UHF.
3. Mount the T matches this way: on the 2-meter end the feed point connectors go towards the front of the antenna. On the UHF part, the forward T match is mounted with the feedpoint connectors towards the front of the antenna, the rear T match has its feed point connector towards the rear of the antenna (see pics on our website)
4. Mount the element rods. The longest rod is the reflector, the Driven Element is the ¼" dia. The element rods mount in descending order of length with the reflector being the longest, Install the nuts as you go. Just snug them, do not apply a lot of torque as it is not necessary. Use wrenches if necessary but just snug them only.
5. Slide the shorting bars onto the T match rods and driven elements. Set the distances as follows for lowest SWR:
2 Meter part: 3 ¼"
70CM part: All the way out (this is the setting for other brands of UHF antennas as well)
The above distances are measured from the inside face of the shorting bars to the end of the T matchbox, not the end of the black bushing.
6. Install the boom to mast plate just behind the last 2-meter element and in front of the second 2-meter T match. Can hold the antenna at a 15 degree angle (recommended if you do not have and elevation rotor). The V clamps V parts butt against the mast.
7. Install the phasing cables. We recommend looking at the pictures on our website to see how they install. Be certain to deep any cables away from element rods, as that will detune the antennas. Never allow a cable to run parallel to an element rod.
== Date: Fri, 28 Feb 20 21:32:01 +0000 From: Luciano Gasparini [email protected] To: AMSAT-NA BB [email protected] Subject: [amsat-bb] Gulf Alpha Antenna Manual
Some years ago I bought a Gulf Alpha 2m/70cm antenna from the factory. I never had the proper location to assemble it until recently. Unfortunately, I cannot find the manual for the above. Could someone help me, please? 73, Luciano PT9KK
_______________________________________________ Sent via [email protected] AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb