Re: [amsat-bb] High Altitude Balloon micro battery recommendation
Skyler, you may want to look at various li-po batteries at your local hobby store. You may find more capacity at the same or close to same weight as watch batteries
73, Ted K7TRK
-----Original Message----- From: AMSAT-BB [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Skyler F Sent: Monday, December 26, 2016 8:21 PM To: amsat-bb@amsat.org Subject: [amsat-bb] High Altitude Balloon micro battery reccomendation
I am going to send up a few micro beacons (milliwatt HF CW transmitters) probably using Walmart balloons and thin wire as the active antenna/payload string.
The CW beacon RF module is a really simple oscillator that drifts a certain amount with temperature - that way I can tell how cold it is based on the received frequency from on the ground. An ATtiny or something similar will probably be used to keep the beacon legal and send out CW every 10 mins to break the carrier.
So the whole RF module and beacon is extremely light, basic transistor/crystal oscillator + ID chip so I don't have to worry about recovery. The only consideration is the battery. I will probably have something operational between 3 and 7 volts, so I am thinking about just stringing a few watch batteries together. Is there a certain recommendation for low temperature operation miniature batteries? I need to make this payload as light as possible.
The goal is the cheapest Amateur Radio balloon project where recovery is not a worry. Signal strength reports across the country as well as wind predictions can get a good idea of where the balloon travelled. I can then match this data up with the daily National Weather Service launch data to determine how high my balloon went based on temperature.
73 Skyler KD0WHB _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
CR123. Almost everything else will freeze. I used a home made pack to power the TT4/Garmin lvc18 for my flight. Worked around 8 hours. Long enough to make it to 78k and into the trees. Recovered a week later when it fell down.
Norm n3ykf
On Tue, Dec 27, 2016 at 5:49 PM, Ted k7trkradio@charter.net wrote:
Skyler, you may want to look at various li-po batteries at your local hobby store. You may find more capacity at the same or close to same weight as watch batteries
73, Ted K7TRK
-----Original Message----- From: AMSAT-BB [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Skyler F Sent: Monday, December 26, 2016 8:21 PM To: amsat-bb@amsat.org Subject: [amsat-bb] High Altitude Balloon micro battery reccomendation
I am going to send up a few micro beacons (milliwatt HF CW transmitters) probably using Walmart balloons and thin wire as the active antenna/payload string.
The CW beacon RF module is a really simple oscillator that drifts a certain amount with temperature - that way I can tell how cold it is based on the received frequency from on the ground. An ATtiny or something similar will probably be used to keep the beacon legal and send out CW every 10 mins to break the carrier.
So the whole RF module and beacon is extremely light, basic transistor/crystal oscillator + ID chip so I don't have to worry about recovery. The only consideration is the battery. I will probably have something operational between 3 and 7 volts, so I am thinking about just stringing a few watch batteries together. Is there a certain recommendation for low temperature operation miniature batteries? I need to make this payload as light as possible.
The goal is the cheapest Amateur Radio balloon project where recovery is not a worry. Signal strength reports across the country as well as wind predictions can get a good idea of where the balloon travelled. I can then match this data up with the daily National Weather Service launch data to determine how high my balloon went based on temperature.
73 Skyler KD0WHB _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
participants (2)
-
Norm n3ykf -
Ted