Can someone offer a little advice about the requirements for using the Fox L-band uplinks? I have an full duplex u/V and v/U satellite station so I'm guessing that my easiest route to L-band is an upconverter. But I've never used anything above UHF, so any thoughts on what might be needed to get started would be appreciated.
73,
Red
KC4LE
I'll add that I'm interested in Antenna/feed setups being used by folks? Rob KA2CZU
On Saturday, January 20, 2018, 4:49:03 PM EST, redski@bellsouth.net redski@bellsouth.net wrote:
Can someone offer a little advice about the requirements for using the Fox L-band uplinks? I have an full duplex u/V and v/U satellite station so I'm guessing that my easiest route to L-band is an upconverter. But I've never used anything above UHF, so any thoughts on what might be needed to get started would be appreciated.
73,
Red
KC4LE
_______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
Initial L-band testing (approximately a 16 deg eastern pass) indicated that it may not take as much power as initially thought to get into the L-band portion of AO-92. One op, N8HM was using an Alinco DJ-G7T handheld with 1 watt and a modified Comet CYA-1216e yagi (boom drilled to accept 2m elements from Arrow antenna. Feed line was 4' of LMR-240UF plus two adapters: BNC to SMA adapter for the HT and BNC to N adapter. Another op, N8TLV, was using an FT-104 hand held with 1 watt, fed into stock rubber duck antenna. Again, this was initial testing and represents my personal observations. I am not affiliated with AMSAT, other than being a member and enthusiastic satellite operator. The Comet CYA-1216e yagi, when combined with Arrow Antennas 2m elements, appears to be a popular antenna for portable operations. M2 Antennas, Directive Systems Engineering, and WiMo offer several antenna choices, depending if you need a tower-mounted antenna or something capable of being handheld. Shorter, high quality coax, with no adapters will always provide a better result. LMR240 or 240UF will be fine for shorter, hand-held runs, LMR400 for moder runs, and LMR600 + for longest runs. As for a preamp, it will depend on your setup. If you need a preamp to hear AO-91, then you will need one to hear AO-92. Hope this helps,73 de KE4AL, Robert EM71
On Sunday, January 21, 2018, 6:49:22 AM CST, Robert Switzer via AMSAT-BB amsat-bb@amsat.org wrote:
I'll add that I'm interested in Antenna/feed setups being used by folks? Rob KA2CZU
On Saturday, January 20, 2018, 4:49:03 PM EST, redski@bellsouth.net redski@bellsouth.net wrote:
Can someone offer a little advice about the requirements for using the Fox L-band uplinks? I have an full duplex u/V and v/U satellite station so I'm guessing that my easiest route to L-band is an upconverter. But I've never used anything above UHF, so any thoughts on what might be needed to get started would be appreciated.
73,
Red
KC4LE
_______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
And I of course left my Alinco DJ-G7T at my summer home in NJ. So I said what the hey, I ordered a 1.2 gig module for my IC-9100, and a Comet CYA-1216e . I found the 1.2 gig antenna at R&L for $134, a new UX-9100 on Ebay shipped to me for a total of $412 from Japan. What a deal :-)
73 Jeff kb2m
-----Original Message----- From: Robert Bankston via AMSAT-BB Sent: Sunday, January 21, 2018 10:58 AM To: amsat-bb@amsat.org ; redski@bellsouth.net Subject: Re: [amsat-bb] L band transmit setup
Initial L-band testing (approximately a 16 deg eastern pass) indicated that it may not take as much power as initially thought to get into the L-band portion of AO-92. One op, N8HM was using an Alinco DJ-G7T handheld with 1 watt and a modified Comet CYA-1216e yagi (boom drilled to accept 2m elements from Arrow antenna. Feed line was 4' of LMR-240UF plus two adapters: BNC to SMA adapter for the HT and BNC to N adapter. Another op, N8TLV, was using an FT-104 hand held with 1 watt, fed into stock rubber duck antenna. Again, this was initial testing and represents my personal observations. I am not affiliated with AMSAT, other than being a member and enthusiastic satellite operator. The Comet CYA-1216e yagi, when combined with Arrow Antennas 2m elements, appears to be a popular antenna for portable operations. M2 Antennas, Directive Systems Engineering, and WiMo offer several antenna choices, depending if you need a tower-mounted antenna or something capable of being handheld. Shorter, high quality coax, with no adapters will always provide a better result. LMR240 or 240UF will be fine for shorter, hand-held runs, LMR400 for moder runs, and LMR600 + for longest runs. As for a preamp, it will depend on your setup. If you need a preamp to hear AO-91, then you will need one to hear AO-92. Hope this helps,73 de KE4AL, Robert EM71
On Sunday, January 21, 2018, 6:49:22 AM CST, Robert Switzer via AMSAT-BB amsat-bb@amsat.org wrote:
I'll add that I'm interested in Antenna/feed setups being used by folks? Rob KA2CZU
On Saturday, January 20, 2018, 4:49:03 PM EST, redski@bellsouth.net redski@bellsouth.net wrote:
Can someone offer a little advice about the requirements for using the Fox L-band uplinks? I have an full duplex u/V and v/U satellite station so I'm guessing that my easiest route to L-band is an upconverter. But I've never used anything above UHF, so any thoughts on what might be needed to get started would be appreciated.
73,
Red
KC4LE
--- This email has been checked for viruses by AVG. http://www.avg.com
participants (4)
-
kb2mjeff@att.net
-
redski@bellsouth.net
-
Robert Bankston
-
Robert Switzer