Thanks for all the feedback on the tracker. A few people commented that it was a bit complex mechanically. This got me thinking about a minimal version where the mechanical section could be built in less than an hour by almost anyone.

Several people asked about moving antennas. The motor in the iPoint has torque of only 35 oz-in. This is at least an order of magnitude less than enough to move an even a small antenna. The main project I am working on is an az-el rotor for small antennas. The azimuth rotor is working and I am working on the mount for the mast. I want to make sure the azimuth rotor is rock solid before working on the elevation rotor. The reason the motor driver in the iPoint is so over designed is that it was designed for the actual rotor not the iPoint. The iPoint actually started out as just a test bed for software development.

A few people have asked about astronomical applications. I have thought about that myself and have been looking for a simple usb telescope to mount on iPoint. It would be interesting to set up SatPC32 to track the moon and let iPoint run all night and capture shots of the moon from the usb tele. The tele would have to be very small and light weight. Does anyone have Kardashian data for heavenly bodies ? Wonder if anyone caught that. I actually would like to know if it is possible to track the moon with SatPc32 and if so where to get the elements.

Here is a short HD video of the minimalist iPoint. While it may be a piece of junk it does work and might give someone some ideas on building something simple but much better than what I did. It did require only a hand drill and a hacksaw and took only about an hour to build. After seeing it you may wonder while it took an entire hour. There is a quarter just to the right of the beast for size reference.

There was quite a bit of discussion on auto license plates a while back. I did not want to contribute to the QRM then but I do have something on that topic at the end of the video. It is actually my photo qsl without the address information - you will understand when you see it. Since I do not operate very often and qsl only when I get one this is probably your only chance to see this rare card. If you look carefully at the back left of the video you can see the azimuth rotor partially disassembled. I keep it there to make me feel guilty when I work on something else.

here is the simplified tracker - I know it is junky so no need to tell me http://www.youtube.com/watch?v=nGwyUdb_vHs

Here is the good tracker in case you missed it http://www.youtube.com/watch?v=gnc4-XcEXEQ

73 tom ...