Yes, that'll work. You'll make your head hurt getting it all set up tho :)

Quick outline of approach:

1) get AWGPE installed and working.

2) install a virtual serial port pair using something like com0com; use baud emulation.

3) install AGWPE KISS-Mode Loopback interface. Configure to use one of the virtual ports; use 9600 baud.

4) Now launch/configure F-1 Telemetry decoder. Pick "the other" virtual com port, use 9600 baud, and then start it.

Use local APRS packet traffic to test...you should be printing it (raw data....

It takes a bit of monkey-ing around, but it works!

73,

Mark N8MH

At 12:29 PM 9/30/2012 -0400, Mark L. Hammond wrote:

Hi Keith,

It's apparently setup to use hardware modems. This shack loves hardware TNCs :)

You might be able to get AWGPE working if you can send KISS data out to a virtual com port...check out http://www.soundcardpacket.org/

"In addition, Tim Pearson KB9VQF has written a http://www.pearsoncomputing.net/freeware.phpAGWPE Serial Loopback utility that creates virtual serial ports that will let you link AGWPE to any packet program that can link to a KISS-enabled TNC (AGWPE's sound card mode simulates a KISS TNC). "

73,

Mark N8MH

At 09:04 AM 9/30/2012 -0700, Keith O'Brien wrote:

...

The F1 Telemetry Decoder Manual in Section 5.2.3 Decode Data OBC2 *You should connect this program with your transceiver first.

Not sure what they are looking for here. I would like to use AGW Packet Engine as my packet TNC. Anyone offer any guidance in how to configure APWPE to the F1 decoder program ? I also have MixW if that would work...

Keith N4ZQ

---

Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb