John,
Yes, the CAN-Do! s were radiation tested and did very well. That was one of the first things done. It was a special PCB that had some alternate parts on it for us to choose from for the final version. The test was run without the Tantalum shields. The Tantalum shields reduce the dose rate so we are very comfortable with the device for the mission. We probably didn't need to shield everything like we did but it's easier to do that after testing the total device rather than try to figure out what each component can tolerate. Our police is to shield any device that contains an FET, top and bottom. I took this into consideration when designing the layout for this and the IHU so there are ICs of similar size on opposite sides of the PCB as much as possible so that the top shield on one provides bottom shielding for the other. It's not possible to shield the bottom of an SMD IC except to put the shield on the other side of the PCB anyway (J-lead SMDs are an exception to this but we don't use very many of them). Tantalum does an outstanding job of shielding. Sometime when I see you, ask me to tell you about the time I forgot I had a piece about 6" square in my brief-case when going through airport security.
Chuck
John B. Stephensen wrote:
Bob:
Were they tested sufficiently for radiation resistance? I'm assuming that the tantalum was used to add radiation shielding for things like flash memory on the MCU. Mirek's receiver also uses flash memory to store the frequency. The PLLs used in the existing 70 cm receiver can be purchased in a pin-compatible rad-hard version. However, the frequency has to be stored in flash memory. PIC MCUs hold data for 40 years on earth but space is a harsher environment.
We have the option of buying PLLs (with more pins) that can be hard-wired to a particular frequency. These PLLs are much more expensive and have longer lead times as they are space rated.
73,
John KD6OZH
----- Original Message ----- From: "Robert McGwier" rwmcgwier@gmail.com To: "Bill Ress" bill@hsmicrowave.com Cc: eagle@amsat.org Sent: Thursday, June 14, 2007 10:46 UTC Subject: [eagle] Re: CAN-Do noise abatement plan and questions
That they were not sufficiently tested by anyone who was to use them to build flight units. This consumed tantalum slides, and lots of effort. Stephen got essentially zero feedback from the engineering test units he sent. This noise issue could have easily been found. They have had the engineering units for a LONG time.
Bob
Bill Ress wrote:
Hi Bob,
Just curious - what were the "objections?"
Regards...Bill - N6GHz
Robert McGwier wrote:
The Germans demanded their flight modules over the objections of the designers and manufacturers so they are on their own with the consequences.
-- AMSAT Director and VP Engineering. Member: ARRL, AMSAT-DL, TAPR, Packrats, NJQRP, QRP ARCI, QCWA, FRC. ARRL SDR WG Chair "If you're going to be crazy, you have to get paid for it or else you're going to be locked up." Hunter S. Thompson _______________________________________________ Via the Eagle mailing list courtesy of AMSAT-NA Eagle@amsat.org http://amsat.org/mailman/listinfo/eagle
Via the Eagle mailing list courtesy of AMSAT-NA Eagle@amsat.org http://amsat.org/mailman/listinfo/eagle