Hi Dick,
Whenever I'm sizing a PCB to fit inside something I always allow 1/2mm around the perimeter.
Chuck
Dick Jansson-rr wrote:
Chuck:
Indeed the machined baseplate width is just 141mm and the cavity is 126mm wide. I would NOT recommend any PCB to be that full width, that it be no wider than 140mm, so theoretically you could have a PCB that is 140x180mm. Perhaps that can be another iteration. (I did not deal with the PCB at all in this round.) Not tonight honey, I've slugged at this beast for six hours today, enough already!
Dick Jansson, KD1K
kd1k@amsat.org mailto:kd1k@amsat.org
kd1k@arrl.net mailto:kd1k@arrl.net
-----Original Message----- From: Chuck Green [mailto:greencl@mindspring.com] Sent: Wednesday, 17 October, 2007 21.46 To: Dick Jansson-rr Cc: Bob Davis; AMSAT Eagle Subject: Re: [eagle] Updated Module
Hi Dick,
This is a good step forward.
I had in mind making the PCB wider so that it extends over the entire
length of the base plate on each side. It seems to me that you could
then make the PCB mounting points less intrusive into the cavity below
the PCB. It looks like I still have that option even if you don't
change the mounting points (true?). And I think that would also better
support the PCB and allow for more thermal contact between the PCB and
the base.
I see that you have more mounting points per linear distance for the
cover than for the PCB. Is this based on vibration modeling?
Also note that the depth of the cavity below the posts is 6.35mm, save
for in the very center where there is an attachment for the connector
plate that is located 0.75mm below the PCB for a space in the center
that is 10mm wide by 6mm deep from the connector plate. I was loathe
to locate such a piece here but felt the need for a third attachment
for the connector plate.
Please reconsider this. It will cause considerable restriction on where
connectors can be located that are also soldered to the PCB. Connector
space/flexibility is a *major* issue.
Chuck