Jim:
You and others have the modules that have been constructed. I have
no idea where they are located…..
’73,
Dick Jansson, KD1K
From: Jim Sanford [mailto:wb4gcs@amsat.org]
Sent: Wednesday, 18 July, 2007 00.40
To: Dick Jansson-rr
Cc: 'Juan Rivera'; 'Chuck Green'; 'David Smith'; 'Dave Black ((Work))';
'Dave Black ((Home))'; 'Louis McFadin'; 'AMSAT Eagle'; 'Samsonoff@Mac. Com';
'Juan.Rivera ((Work))'
Subject: Re: [eagle] Re: CAN-Do Suggestions from Juan
DIck:
Do you know where any exist? Let's get them in Juan's hand and SEE.
73,
Jim
Dick Jansson-rr wrote:
Juan:
You
keep commenting on the flexure of the PCB and relate it to the module hardware
that you have in hand. It is my very greatly considered opinion that the
baseplate that you have has been modified (butchered) to allow for the
soldering of the CAN 40pin connector and this has created not only reduced
sections in this plate, but probably has also distorted the plate considerable.
Such distortions in all likelihood have created a non-normal flexure condition
in that particular plate. As such, your opinion of the design has been biased,
and that is unfortunate. It seems to me that you should try to acquire an
E05 21 base plate that is in “stock” condition. I don’t have any in hand
here in Florida, or I would have sent it to you some time ago. These parts,
unfortunately are in a limited supply at this time.
’73,
Dick
Jansson, KD1K