Juan: As usual, good work, and well documented -- thanks!
What is your plan for proceeding to execution of the ATP?
After you've developed a test configuraton and executed/documented the ATP, I'd like to see a single document, titled "Recommended changes to design," which would be the single summary of all you've learned and would recommend we do different in this design. As always, I'm open to a better idea.
THanks & 73, Jim wb4gcs@amsat.org
Juan Rivera wrote:
All,
I've completed a preliminary evaluation of the CAN-Do RFI problem. Please see my log for details by clicking here http://www.juanr.com/pages/hobbies/ham_radio/Eagle/CAN-Do_Noise_Troubleshooting.htm.
Preliminary Findings...
- The spurs seen in the receiver IF enter the receiver in two ways
o As radiation from the CAN-Do inductor
o Via CAN-Do module switched +14 VDC power on pins 39 and 40
I/O line filtering appears to be unnecessary
The switched power from the CAN-Do module pins 39 and 40 must be
filtered
- The CAN-Do module will either have to be kept physically
separated from any sensitive components, redesigned, shielded or a combination of the three.
- Moving the Can-Do module 2-1/4" forward of its normal location
on the receiver PCB lowers the EMI level below the noise floor.
Suggestions...
· Create a full size PCB for the next generation receiver and shift the RF components to the back of the board (away from the CAN-Do module.)
· Add DC input filtering to the receiver
73,
Juan
WA6HTP
Via the Eagle mailing list courtesy of AMSAT-NA Eagle@amsat.org http://amsat.org/mailman/listinfo/eagle