Juan:
You
keep commenting on the flexure of the PCB and relate it to the
module hardware that you have in hand. It is my very greatly considered
opinion
that the baseplate that you have has been modified (butchered) to allow
for the
soldering of the CAN 40pin connector and this has created not only
reduced
sections in this plate, but probably has also distorted the plate
considerable.
Such distortions in all likelihood have created a non-normal flexure
condition
in that particular plate. As such, your opinion of the design has been
biased,
and that is unfortunate. It seems to me that you should try to acquire
an
E05 21 base plate that is in “stock” condition. I don’t
have any in hand here in Florida, or I would have sent it to you some
time ago.
These parts, unfortunately are in a limited supply at this time.
’73,
Dick
Jansson, KD1K
kd1k@amsat.org
kd1k@arrl.net