Bob,

 

Thanks.

 

I’ll look at the 570 data sheet and see what it says about pullup resistance.

An input can be configured with either a  pullup, pulldown or nothing.

 

Want to start a group pool to bet on how many iterations it will take to get the configuration correct?

Not that difficult but easy to loose ones place going between your pin chart and the HCG settings.

 

73,

 

Jim McCullers

WA4CWI

 

 

 

Jim,

 

Yes need to be sure the pull ups are enabled on these IRQ lines which will be inputs. 

 

Ok to have pull ups on all inputs. If we have a problem meeting the Vol input level we can disable later. 

 

Pull-ups are probably a high resistance, maybe 100K?

 

I have several external pull ups and a few pull downs. 

 

POR could be a special case but we can start with pull-up. 

 

Bob



On Nov 19, 2023, at 7:07 AM, Burns Fisher (AMSAT) via pacsat-dev <pacsat-dev@amsat.org> wrote:



You should double check this but I seem to remember that the internal pull-up/downs only work for INPUTS. Not sure if for example they would work on i2c. FWIW

 

On Sat, Nov 18, 2023 at 10:41 PM Jim McCullers via pacsat-dev <pacsat-dev@amsat.org> wrote:

Bob,

 

In the last column labeled Pullup/Down does “Add on chip pullup” mean set the pullup with the HCG configuration?

My assumption is yes but wanted to crosscheck before defining.

 

The configurator assigns a pullup to all inputs by default.

If not required I assumption they will need to be manually reset in HCG.

 

 

Thanks

 

Jim McCullers

WA4CWI


-----------------------------------------------------------

pacsat-dev mailing list -- pacsat-dev@amsat.org
View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org
To unsubscribe send an email to pacsat-dev-leave@amsat.org
Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org


-----------------------------------------------------------

pacsat-dev mailing list -- pacsat-dev@amsat.org
View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org
To unsubscribe send an email to pacsat-dev-leave@amsat.org
Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org