Ok great. That seems to work. Here is the mram command output:Pacsat>>test mram 80
Starting at address 80:
Data 1 should be 1 1 1 1 8 10 12 14
First read/write cycle for data 1 is 1 1 1 1 8 10 12 14
Second read/write cycle for data 1 is 1 1 1 1 8 10 12 14
Starting at address 80:
Data 2 should be 2 2 2 2 3 2 1 30
Read back for data 2 is 2 2 2 2 3 2 1 30But the mram wren does not work as expected. First this:Pacsat>get mram sr
MRAM status is efHmm, so I did these two commands:Pacsat>mram wren
stat for Wren is 1; sr is 2Pacsat>>get mram sr
MRAM status is 2Is that what you expect?73ChrisOn Fri, Dec 2, 2022 at 2:22 PM Burns Fisher (AMSAT) <wb1fj@fisher.cc> wrote:Oops! I totally forgot! On J11, 32 is ground, 33, 34 for Rx and Tx (I just reversed them till it worked). It is still 38k4 baud.73,Burns Fisher, WB1FJAMSAT(R) Engineering -- Flight SoftwareOn Fri, Dec 2, 2022 at 2:17 PM Chris Thompson <chrisethompson@gmail.com> wrote:Hi Burns,This compiles and flashes fine here, but I think I need to know the new UART pins. I think you moved them from the HET, right?73ChrisOn Fri, Dec 2, 2022 at 10:53 AM Burns Fisher (AMSAT) <wb1fj@fisher.cc> wrote:-----------------------------------------------Hi,As discussed last night, I have a HALCoGen configuration set up that is specifically designed for the LaunchPad. I've also added a command "test mram" and another called "mram wren". The former writes 10 bytes into the mram at a specified address and then reads them back. It prints what it was writing, and what the read-back results are. It does this twice with one pattern of data and once with a different one. You can specify an address following the command. For example "test mram 100". It will take 0xnnn" as well for hex"mram wren" sends a write enable command to the mram. The existing command "get mram sr" should show this. If it returns "40" the chip is not write enabled. If it returns 42, it is write enabled.There is also, in config.h, a #ifdef FRAM64K. If this is set, the address sent to the non-volatile RAM is 2 bytes. If it is not defined (just comment it out) it will be 3 bytes. I've left it set up for 3-byte addresses since that is what Chris is using.Please let me know if you have tried this successfully, especially with a real MRAM (most of those tests were for my funky F-RAM). If so, I'll move it to the main branch.73,Burns Fisher, WB1FJAMSAT(R) Engineering -- Flight Software
pacsat-dev mailing list -- pacsat-dev@amsat.org
View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org
To unsubscribe send an email to pacsat-dev-leave@amsat.org
Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org
--
--