Jonathan, did I send you the extra Launchpad that I ended up with?  In any case, do you want to give one to Corey? Corey, you may have to solder on some .1" header pins for Jim's board to have all the required connections.  I know the headers are DNP around the outside where they are not used, but I'm not sure that all the inside ones are there either.  

73,

Burns Fisher, WB1FJ

AMSAT(R) Engineering -- Flight Software

On Fri, Apr 7, 2023 at 12:30 PM Corey Minyard via pacsat-dev <pacsat-dev@amsat.org> wrote:

I have the filesystem code mostly ready.  I changed the configuration
to use 256 byte block.  It's available in the filesystem branch.

So I will need a launchpad and a board with MRAM.  My address is:

7406 Wheatfield Rd, Garland, TX 75044

Chris, you can test it if you like, too.  I haven't written any tests
for anything yet, that needs to be added.

There is code to automatically mount the filesystem on startup and
format the filesystem if it detects corruption.

There are three new console commands:  mount fs, unmount fs, and format fs.

The commands are the normal POSIX commands with "red_" prefixed,
red_open(), red_close(), read_read(), etc.

I need to write a README about how this is all set up.

-corey

-----------------------------------------------------------

pacsat-dev mailing list -- pacsat-dev@amsat.org
View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org
To unsubscribe send an email to pacsat-dev-leave@amsat.org
Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org

-----------------------------------------------------------

pacsat-dev mailing list -- pacsat-dev@amsat.org
View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org
To unsubscribe send an email to pacsat-dev-leave@amsat.org
Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org