Just realized that the second temp sensor is not on this board. I took it off to change address and have not put it back yet. Probably will work fine. ________________________________ From: Burns Fisher (AMSAT) via pacsat-dev pacsat-dev@amsat.org Sent: Monday, February 5, 2024 3:53 PM To: Bob Stricklin bstrick@n5brg.com Cc: Bill via pacsat-dev pacsat-dev@amsat.org Subject: [pacsat-dev] Re: One board now talking
Oh, I see. So this is saying that I2c in general is ok, but that the temp sensor near the CPU is not working for whatever reason (bad bus connection, bad address bit connection, or bad chip).
And regarding the MRAM, I have the chip select wrong on at least one of those MRAM devices. I just found that earlier and did not push it up to the repository.. Let me check what else I have done since I pushed upstream, and if all is ok, I'll push this change too. Looks like most everything in the MRAM is ok otheriwise (whew! Was driving me crazy)
I see you sent something else. Have not seen it yet but will send this.
73,
Burns Fisher, WB1FJ AMSAT(R) Engineering -- Flight Software
On Mon, Feb 5, 2024 at 4:43 PM Burns Fisher (AMSAT) <wb1fj@fisher.ccmailto:wb1fj@fisher.cc> wrote: Ok, looks like two of the MRAMs are ok, and two are not for whatever reason. Oh, I bet I know...I think I got the chip select lines wrong on one or two of them. Funny the temp actually looks ok despite the error. In the middle of checking something else. Will get back after a bit more testing. 73,
Burns Fisher, WB1FJ AMSAT(R) Engineering -- Flight Software
On Mon, Feb 5, 2024 at 4:41 PM Bob Stricklin via pacsat-dev <pacsat-dev@amsat.orgmailto:pacsat-dev@amsat.org> wrote: Pacsat> Pacsat>get mram sr MRAM0: status 32, MRAM1: status ff MRAM2: status 2, MRAM3: status ff Pacsat>get temp CPU Temp request failed Transmitter temp: 99 ( 29.5 degrees C) Pacsat>
________________________________ From: Burns Fisher (AMSAT) <wb1fj@fisher.ccmailto:wb1fj@fisher.cc> Sent: Monday, February 5, 2024 3:35 PM To: Bob Stricklin <bstrick@n5brg.commailto:bstrick@n5brg.com> Cc: Bill via pacsat-dev <pacsat-dev@amsat.orgmailto:pacsat-dev@amsat.org> Subject: Re: [pacsat-dev] One board now talking
Oh, I just sent you a mail before seeing this.
Wow! Looks like there may be something wrong with my board. Could you do "get mram sr" please? You could try "get temp" also.
I'm not sure if those are the right values for the DCT (the AX5043). I know I had a quick way at one point that I could tell if one particular register was correct. I'll see if I can find it.
73,
Burns Fisher, WB1FJ AMSAT(R) Engineering -- Flight Software
On Mon, Feb 5, 2024 at 4:24 PM Bob Stricklin via pacsat-dev <pacsat-dev@amsat.orgmailto:pacsat-dev@amsat.org> wrote: After getting TX and RX connected correctly now working. Do not know what the correct report back is but here is some checks...
This board has four 4Mb MRAMs installed.
Pacsat>get version
AMSAT-NA PacSat Console Flight Software X0.1k (built on Feb 4 2024 at 21:53:10) Compiled *RELEASE* **X, E, U, or DEBUG Version: Not configured for flight** Watchdog NOT Enabled Using FreeRTOS withOUT premption enabled; Free heap size is 75504 Flash memory size 1Mb+0Kb MRAM config data partition size=1008, file system size=1047568 Pacsat>>get version
AMSAT-NA PacSat Console Flight Software X0.1k (built on Feb 4 2024 at 21:53:10) Compiled *RELEASE* **X, E, U, or DEBUG Version: Not configured for flight** Watchdog NOT Enabled Using FreeRTOS withOUT premption enabled; Free heap size is 75504 Flash memory size 1Mb+0Kb MRAM config data partition size=1008, file system size=1047568 Pacsat>
Pacsat>get RSSI RSSI is -64 dBm Pacsat>
Pacsat>get ax AX5043 dev 1 TX: FIFOSTAT: 00 PWRMODE:: 77 XTALCAP: 119 PLLLOOP: 77 PLLCPI: 77 PLLVCOI: 77 PLLRANGINGA: 77 PLLVCODIV: 77 FREQ 1911466666 Hz MODULATION: 77 TXPWRCOEFFB0: 77 TXPWRCOEFFB1: 77
AX5043 dev 0 RX: FIFOSTAT: 00 PWRMODE: 67 XTALCAP: 103 PLLLOOP: 67 PLLCPI: 67 PLLVCOI: 67 PLLRANGINGA: 67 PLLVCODIV: 67 FREQ 1654462744 Hz MODULATION: 67 TXPWRCOEFFB0: 67 TXPWRCOEFFB1: 67 Pacsat>
-----------------------------------------------------------
pacsat-dev mailing list -- pacsat-dev@amsat.orgmailto:pacsat-dev@amsat.org View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org To unsubscribe send an email to pacsat-dev-leave@amsat.orgmailto:pacsat-dev-leave@amsat.org Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org
-----------------------------------------------------------
pacsat-dev mailing list -- pacsat-dev@amsat.orgmailto:pacsat-dev@amsat.org View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org To unsubscribe send an email to pacsat-dev-leave@amsat.orgmailto:pacsat-dev-leave@amsat.org Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org