Chis,
It was showing up at boot and when I executed the test rx command.
I can’t remember if or how much I tested before rewiring the receiver transformers then having the power supply go out.
If I did test it was just for startup and I would have ignored the messages.
I’ll reset the RAM once the updated code is in place.
Thanks
Jim
Jim,
The receiver frequency for each chip is stored in MRAM. So if you have them set to the same frequency that will stay there. You need to reset the MRAM to get the defaults.
I think a ranging error will show up at boot, printed in the console, but I could be wrong.
73
Chris
On Thu, Apr 25, 2024, 12:51 Jim McCullers via pacsat-dev <pacsat-dev@amsat.org mailto:pacsat-dev@amsat.org > wrote:
Bob,
I finally got everything back in place and brought Blinky up last night. I'm getting a ranging error on device 0 and no messages from the others Same when I attempt the rx command. All four receivers are showing the same frequency.
I checked this morning and I'm not running the latest code so have it downloaded and will test tonight if possible. If it goes well, I'll look into your question. Technically all four receives should have the same PLL value as the PLL should range over the two meter band. I'll look at that as well. Have to deep dive into the manual.
I'm suffering from a stiff neck this week and not able to do much. Always something!
Jim WA4CWI
Looking at the feedback from the reading the AX5043 devices I see two have different PLL vales. The PLL sets the frequency conditions so this may be involved with the two devices that do not seem to be working.
A listing of the register values reported is attached.
Also the code I think is setting these registers. I have not had time to dig into the code. If an issue can be seen by someone that has looked at this code I would appreciate the help.
Bob
-----------------------------------------------------------
pacsat-dev mailing list -- pacsat-dev@amsat.org mailto:pacsat-dev@amsat.org View archives of this mailing list at https://mailman.amsat.org/hyperkitty/list/pacsat-dev@amsat.org To unsubscribe send an email to pacsat-dev-leave@amsat.org Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org