Version X0.2a pushed upstrem. This is all still in the branch WB1FJ_Port_to_Blinky

First you will note that it will frequently tell you that you have the wrong MRAM version. Some of these warnings were commented out. I may have done it in debugging, but it is important. Lots of things may not work right if this message appears. It gives several alternatives of commands that you can issue, but in this particular case,

YOU MUST ISSUE THE COMMAND 'init new proc'.

After that the messages will stop. The reason for all this is that I added 3 more receive frequency locations in MRAM, and those are only set up with init new proc.

This new version, as I implied above, saves 4 different receive frequencies. "init new proc' initializes them all the same, but you can adjust them with "raise rx freq n m" where n is the receiver number (1-4) and n is the number (in Hz) to raise the frequency by. There is also 'lower rx freq'. The versions for tx freq do not have a chip number. The maximum you can change the frequency for any of these (I think) is 32767Hz (it is 15 bits).

BTW, I think this is actually transmitting something. If I have the tx frequency set out of range, I get a TX queue filling up. ??????

Anyway, let me know if you have questions or if you need other stuff. I'm done for now. And btw, we are again expecting snow Tuesday, so my band rehearsal may be moved to Thursday again :-(

73,

Burns Fisher, WB1FJ *AMSAT(R) Engineering -- Flight Software*