Hi Mark,
That is the way they're supposed to work. +12v receive - 0v on xmit.
It is fine with a Yaesu FT-736R using the built in preamp feed system - power up the coax. Just have to watch out for any DC block.
It also would work with a Yeasu FT-847 if it had 1296.....
I had one for a while. I found I had to open it up and retune as it was set for the low end of the 23cm band?!? My biggest problem was that it was only good for about 15 watts. I had to use it after my DL2AM 80 watt amp....
Mike
----- Original Message ----- From: "Mark L. Hammond" [email protected] Subject: [amsat-bb] Re: Icom AG-35 Preamp Question
Hi All,
Somebody please clarify---I may be wrong, but I thought the Icom preamps did the following with Icom radios:
In receive, 12V is powered up the coax. Device is powered, preamp is ON. In transmit, the 12 power feed is stopped. Device is not powered, and it's bypassed during xmit.
If this is the case, it complicates greatly the use of Icom preamps on non-Icom radios (means there isn't a typical RF-sensed bypass circuit, which means it would be easy to blow in a non-Icom radio).
Am I remembering this wrong?
Mark N8MH
At 09:30 PM 8/11/2012 -0700, Art McBride wrote:
Rick, I suggest you use a VOM or DMM to measure the current drawn on 12 volts going to the power injector. If everything is connected correctly It will draw 30-200 mA. Confirm that you have continuity in your coax. Some lightning arrestors have a DC block built in. It is best to test it with a short run of coax between the preamp and the power injector at the radio while listening to a local repeater to see if the signal increases when you apply power to it. If it operates then you can proceed to determine if there are problems with the coax to the antenna, not carrying the 12 VDC. 73 Art, KC6UQH
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Lawn, Richard Sent: Saturday, August 11, 2012 3:30 PM To: [email protected] Subject: [amsat-bb] Icom AG-35 Preamp Question
I bought an Icom AG-35 preamp about a year ago. The fellow ham advertised it as virtually brand new and it was/is. I planned to use it this summer with a TS-2000 which doesn't supply 12v voltage to the coax to power a preamp as other xcvrs do. I used a Mirage KP2 unit to inject power to the coax to drive mast mounted the preamp. When I turn the power on there seems to be little or no noticeable difference in background noise and worse than that I cannot here any signals on FO-29 downlink, and I know the bird has been active. Any suggestions? Is the preamp fried? I can't even get the weather proof case off to trouble shoot, not that I'd know what to look for. Any suggestions on repair?
TNX 73 Rick W2JAZ
Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb