Hi Les I had same problem with my IC-910, the culprit was a pin diode, namely D710 1SV625, usually cause damage by static problems. It's not too difficult to change. If you dominate some Spanish, you can see the evolution of my rig in this thread: http://www.ure.es/foro/5-vhf-uhf/86547-icom ic-910H-has-lost-sensitivity-rx -en-vhf-bis.html Good luck 73´s Luis
2014-08-14 17:27 GMT+02:00 Les Rayburn [email protected]:
Can someone recommend a repair service that has experience with the unique needs of VHF/UHF weak signal operation? My IC-910H is "ailing" and I don't want to be without it for long.
I noticed that signals on 2M satellites sounded a bit weaker than normal, but I attributed that to random phasing. Then during the Perseid meteor showers, all my QSO's turned into marathon events, many lasting well over an hour. Even at distances that should have been easy, and with stations running high power. I investigated further by monitoring two local beacons, and noticed that one was much weaker than normal, and the other could not be copied at all. Using WSJT, I couldn't even see the faint trace of the carrier.
Also checked local NOAA weather stations...and I can normally copy at least one station on each frequency. Now, I can only seem to manage to hear stations on the two of them. Something is amiss. I swapped out cables, checked connections, etc. Nothing improves the situation. Transmit output power is normal on all bands.
The problem appears to be isolated to 2 Meter receive, but it's difficult to check other frequencies here.
Any recommendation on where to send my baby?
--
73,
Les Rayburn, N1LF 121 Mayfair Park Maylene, AL 35114 EM63nf
6M VUCC #1712 AMSAT #38965 Grid Bandits #222 Southeastern VHF Society Central States VHF Society Life Member Six Club #2484
Active on 6 Meters thru 1296, 10GHz & Light
Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb