----- Original Message ----- From: "Michael Fletcher" [email protected] To: [email protected] Sent: Saturday, May 29, 2010 3:55 PM Subject: [amsat-bb] P3E/P5A S -> X transponder
Hi all ye Microwavers,
AMSAT-OH is working on the S/X band coherent/linear transponder for P3E. The Coherent mode is a fully functional testbed for the P5A ranging transponder.
Especially the linear transponder prototype has been assembled and verified with over-the-air tests and laboratory tests. Flight versions of the submodules have been and are being produced at this time with our eyes now set on integrating these together and cabling the whole job together.
Full verification of the Coherent Mode requires a fully functional command station AND a functional IHU + CAN environment to interface our data ports with. No such tests have been available yet, but all our preliminary testing and evaluation of the Coherent Processor have shown proper operation of the design and circuitry (e.g. locking onto a "modulated" uplink carrier, tracking this etc.). So far correct live operation of the Coherent Mode is our biggest questionmark.
Our national team meets on a regular basis every 4 - 6 weeks for testing and followups of the work of each individual.
This transponder is especially complex as you can see from these key figures:
* 9 different local oscillators * All local oscillators locked to the common 10 MHz USO * 21 different frequency mixers * 13 different intermediate frequencies * Linear Mode output power on 10 GHz: 3 W PEP * P5A Mode output power on 10 GHz: 1 mW PEP * 38 control lines on the CAN interfaces * 2 CAN interfaces, one in multiplexed mode * 4 dedicated direct control lines interfacing with the IHU * 14 analogue telemetry lines to the CAN bus * Coherent Mode Uplink/Downlink ratio is fixed at 30:7Here you may find a general outline webpage, though unfortunately in Finnish for the benefit of our OH supporters, but you might still enjoy the photos and drawings:
http://www.rats.fi/rats/amsat-oh/
Our team sincerely hopes funding will eventually be found for P3E/P5A - this is the only thing that keeps us motivated to continue our work. On the other hand we are clearly behind schedule, so the delays are welcome :-) But then again, any news of progress would boost our production rate phenomenally ;-)
73 Michael, OH2AUE
-- "Life is too short for Sudoku"
Hi Michael, OH2AUE
I am very happy to see that AMSAT-OH is working on the S/X band coherent/linear transponder for P3E/P5A
Don't forget what you promises on 11 may 2008 about the frequency band for the Downlink Linear 10451.000 MHz ~2 MHz because many of us are already equipped with X band downconverters and dishes covering from 10450.000 to 10452.000 MHz originally made for AO40 never tested on it and now becaming rusty on the roof as you can see at i8CVS in QRZ.com
From your block diagrams written in finnish I see that 10.450 GHz is still
there and I am very happy with it.
Here is your original text written for AMSAT-BB on 11 may 2008
There is some contradicting information around regarding the S band receiver and X band transmitter, but here are the frequencies the engineering and flight models are being synthesized and crystalled for as per our efforts to get at least the X band downlink to a more "standard" frequency:
Center Frequencies for the IF center frequency of 10.700 MHz:
U/D Mode Center Frequency Bandwidth
Uplink Coherent 2438.567 MHz ~2 MHz Uplink Linear 2439.000 MHz 38 kHz Downlink Coherent 10451.000 MHz ~2 MHz Downlink Linear 10451.000 MHz ~2 MHz Beacon BPSK 10451.030 MHz NB, Modulation dependent
These frequencies were last published in the AMSAT-DL Journal Nr.4 Jg.33, any other public sources may be unreliable.
73's Michael, OH2AUE "Life is too short for Sudoku"
Tanks for your information and 73" de
i8CVS Domenico