You can configure AGWPE for the KAM TNC and make sure to provide the commands in AGWPE to initialize in the KISS mode then use UISS to communicate with the ISS.
IniKiss1: XKCH OFF IniKiss2: INTFACE KISS IniKiss3: RESET
ExitKiss On Exit Checked
I have read XKCH OFF and INTFACE KISS sometime's is not recognized by KAM, I use ^M with MFJ 1278B and it works.
73 Nitin [VU3TYG]
From: JoAnne Maenpaa [email protected] To: [email protected] Sent: Friday, 20 June 2014 6:22 AM Subject: Re: [amsat-bb] TNC Question
Hi Kelley,
... searching for settings specific to this unit for ARISS work
I'm not familiar with the Kantronics syntax for typing commands but see below for a general summary of the parameters you may find useful.
ARISS has a summary of hardware TNC and soundcard TNC operations posted at: http://www.ariss.org/uploads/1/9/6/8/19681527/k9jkm_2012_symposium_ver 2.pdf (careful, might line wrap this URL)
The list of parameters you will find useful but may need to adapt to Kantronics syntax:
MYCALL - Your Callsign Default is NOCALL, but you want others to know you are there.
DAYTIME - YYMMDDHHMM Used if you want to timestamp the packets you are receiving.
MONITOR ON - Displays all packets on the frequency
MALL ON - Displays all packets on the frequency (connected or unconnected)
MCOM ON - Displays the AX.25 protocol with the message (might clutter your screen)
MCON ON - Allow you to see all packets even when in CONVERS mode
MSTAMP ON - Monitored packets are timestamped
MRPT ON - Displays the entire digipeat path for the packets.
CONSTAMP ON - Connect and disconnect status messages are timestamped
HEADERLN ON - Header information is displayed on separate line from message text
PASSALL ON - TNC will accept and display packets that have errors (noise). Partial packets, even with errors, are often still readable to the human eye.
PASSALL OFF - TNC will only accept and display packets that have complete CRC.
CONVERS <enter> - Mode to type packet message from keyboard directly to the TNC. Ctrl-C will exit CONVERS mode.
MHEARD <enter> - Displays your TNC's "heard" list (updated only when PASSALL OFF)
UNPROTO CQ VIA ARISS - Most basic string for ARISS to copy, route, and digipeat your packet
-- 73 de JoAnne K9JKM [email protected]
Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb