Tim/all- I did a repair on my G5500 el rotor. I needed a position pot-it was available through Yaesu parts right away. Depending on what you need to have done, your mileage may vary. You could always ship the whole thing to Yaesu. You can get lots of advice here on the bb. 73 Bob W7LRD
----- Original Message -----
From: "Tim Goodrich" [email protected] To: [email protected] Sent: Saturday, July 5, 2014 5:35:52 PM Subject: [amsat-bb] az-el rotor repair
Hi All,
I have a Yaesu G5400b controller with a kenpro az/el rotor. From my understanding, yaesu was taken over by kenpro and the parts inside the az/el rotor are the same as in a yaesu 5400 setup. Anyway, my rotor is in need of repair and it seems there is a shortage of people who do these repairs, not to mention have parts on hand to make the repairs (apparently replacement parts from yaesu seem to be in short supply). Can anyone recommend a technician for this who might have the parts?
Thanks,
Tim
K6TW
_______________________________________________ Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb