I've been trying to get my receive setup going the last few days but I'm having horrible results. I have my 11 element 70cm "cheap yagi" back up on the mast and my homebrew SaebrTrack and OR-360 AZ/EL TV rotator system interfaced to SatPC32. I have an ARR preamp mounted at the mast fed with a seperate 12VDC feed and about a 40 foot run of JEFA brand LMR 400. Once I get into the shack there is a bit of patchwork to the cables. I'm using a Yaesu VX3 to receive and due to the SMA connector on the HT and not wanting to strain it I have a 4 foot adapter cable of LMR 100 that goes from an SMA to a SO-239. I then have to use a short length of coax with a PL-259 to N male to mate up with a N barrel connector connected to my LMR 400 coming from outside. Now obviously, I know this isn't optimum and eats up valuable RF and I intend to change it ASAP but I'm hearing absolutely nothing on AO-51 passes. Not even the hint of signals. I'm thinking with that preamp in the line I should at lest hear something discernible besides noise regardless of the patchwork of cables. Am I off base in thinking this? I did catch just a bit of discernible signal off SO-50 last night but it was almost overhead. I'm not a beginner at this but I'm frustrated. Perhaps I'm putting too much faith in the preamp to push the signals through my hodgepodge of adapters and cables? Any thoughts are appreciated. 73, Michael, W4HIJ