FlexSatPC current version is v.8.7.4. Your version is pretty old. You may be due for an update.
On Tue, Feb 19, 2019 at 23:39 Allen [email protected] wrote:
Hi All, For several months I have been automatically receiving frames from the Fox-1 satellites. Typically at –3 degrees elev, the az/el sets the antenna position correctly and the radio is tuned to the correct frequency. But lately as soon as 0 degrees el is reached, SatPC32 stalls, the clock stops and nothing further happens until I manually click on the enabled satellite. Everything again proceeds normally, until the next scheduled satellite reaches 0 degrees el and SatPC32 stops. Since this error I upgraded from Ver 12.8c to 12.8d which produced the same error. I reinstalled 12.8c but the condition persists. In receive only mode, I’m using a Flex 1500 with FlexSatPC 7.2.2 and the computer uses Win10 Pro with an i7 processor and 8GM RAM. CPU demand always is less than 10%. I’m at a loss as to where to look to resolve this issue. Any guidance is greatly appreciated.
73, Allen KI7RM _______________________________________________ Sent via [email protected]. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb