It definitely works on Windows 10, so that is not the problem. (I also have a TS2000). Are you seeing the frequency numbers change in the middle of the SatPC32 screen? Is the "C" switch (top left) showing C+ and not C-?
On Thu, Mar 28, 2019 at 9:01 PM Mike [email protected] wrote:
I was successfully using Windows 7 to run SatPC32 and suffered a catastrophic failure of the computer so I had to replace it.
I replaced it with a used Windows 10 computer.
I can install SatPC32 and get it set up, as best as i remember how to do. Things seem to be working except for the doppler tracking of the CAT control. I know SatPC is talking to my TS-2000 because it goes into satellite mode when I start SatPC. Also, I can click on the CW tab and it changes to CW and back when I deselect it. But no doppler tracking control.
I'm at a loss as what to do at this point.
Thanks for any help.
Mike Stansberry, K0TER
Sent via [email protected]. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb