You can't use regular audio, because it has the low frequencies we are using for the data filtered out. That includes the sound through your Signalink.
Use must either use an SDR source, or the audio from the data out pin on the back of your radio. Section 4.3 in the manual.
73, Drew KO4MA
-----Original Message----- From: AMSAT-BB [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Bob KD7YZ Sent: Thursday, October 08, 2015 8:08 PM To: AMSAT BB Subject: [amsat-bb] Guess I need Help with Fox-1A Software and IC910
Disappointing. I normally decode ARISS as well as local APRS. I heard the Voice ID gal very strongly, numerous times. The program was set to get audio from the SignaLink USB just as MixW and UISS are. Though they were no loaded.
On the IC910, I set "9600" on then after a while OFF then switched it back again later.
Got no decodes nor heard anything in the form of a signal except the Fox1 Safe Mode gal.
Can I get some guidance before nest pass?
thanks
-- 73, Bob KD7YZ www.qrz.com/db/kd7yz AmSat LM#901 _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb