On Fri, Apr 28, 2023 at 01:29:19AM +0000, Burns Fisher (AMSAT) via pacsat-dev wrote:
- The pins to use on the launchpad are j2 pin 3 (RX) and 4 (Tx). Nearby,
J3 pin 2 is ground. Note that each row is a different "J" number on the board, and the count 1,2,3 etc from the USB connector end. Jim numbered them on his schematic somewhat more sensibly, but they don't match the board.
Looking at the launchpad schematic, are you sure that's not J3?
-corey
On Thu, Apr 27, 2023 at 08:42:09PM -0500, Corey Minyard wrote:
On Fri, Apr 28, 2023 at 01:29:19AM +0000, Burns Fisher (AMSAT) via pacsat-dev wrote:
- The pins to use on the launchpad are j2 pin 3 (RX) and 4 (Tx). Nearby,
J3 pin 2 is ground. Note that each row is a different "J" number on the board, and the count 1,2,3 etc from the USB connector end. Jim numbered them on his schematic somewhat more sensibly, but they don't match the board.
Looking at the launchpad schematic, are you sure that's not J3?
Oh, wait, I got the wrong launchpad board. Never mind.
-corey
-corey
On Thu, Apr 27, 2023 at 08:48:16PM -0500, Corey Minyard wrote:
On Thu, Apr 27, 2023 at 08:42:09PM -0500, Corey Minyard wrote:
On Fri, Apr 28, 2023 at 01:29:19AM +0000, Burns Fisher (AMSAT) via pacsat-dev wrote:
- The pins to use on the launchpad are j2 pin 3 (RX) and 4 (Tx). Nearby,
J3 pin 2 is ground. Note that each row is a different "J" number on the board, and the count 1,2,3 etc from the USB connector end. Jim numbered them on his schematic somewhat more sensibly, but they don't match the board.
Looking at the launchpad schematic, are you sure that's not J3?
Oh, wait, I got the wrong launchpad board. Never mind.
It's working fine now. Thanks.
-corey
-corey
-corey
Great! 73,
Burns Fisher, WB1FJ *AMSAT(R) Engineering -- Flight Software*
On Thu, Apr 27, 2023 at 10:04 PM Corey Minyard minyard@acm.org wrote:
On Thu, Apr 27, 2023 at 08:48:16PM -0500, Corey Minyard wrote:
On Thu, Apr 27, 2023 at 08:42:09PM -0500, Corey Minyard wrote:
On Fri, Apr 28, 2023 at 01:29:19AM +0000, Burns Fisher (AMSAT) via
pacsat-dev wrote:
- The pins to use on the launchpad are j2 pin 3 (RX) and 4 (Tx).
Nearby,
J3 pin 2 is ground. Note that each row is a different "J" number on
the
board, and the count 1,2,3 etc from the USB connector end. Jim
numbered
them on his schematic somewhat more sensibly, but they don't match
the
board.
Looking at the launchpad schematic, are you sure that's not J3?
Oh, wait, I got the wrong launchpad board. Never mind.
It's working fine now. Thanks.
-corey
-corey
-corey
participants (2)
-
Burns Fisher (AMSAT) -
Corey Minyard