Thank you Jim. The antenna tested fine (initially) with all of the phasing lines connected. The issue didn't present itself until the antenna was mounted to the boom and everything was secured (wire ties etc).Kind Regards, Mark Morris -------- Original message --------From: Jim_WØNBC [email protected] Date: 12/27/22 12:22 PM (GMT-05:00) To: markemorris [email protected], [email protected] Cc: [email protected] Subject: Re: [AMSAT-BB] Leo Pack issue Just talked to him and he said that when got the phasing cable right the SWR was flat across the band. So hopefully that is your issue too. Jim, W0NBC. Sent from Yahoo Mail for iPhoneOn Tuesday, December 27, 2022, 11:08 AM, Jim_WØNBC [email protected] wrote: A friend had an issue also and he said the phasing cable were marked wrong. Not sure if that is your issue. Jim, W0NBC. Sent from Yahoo Mail for iPhoneOn Tuesday, December 27, 2022, 10:59 AM, markemorris via AMSAT-BB [email protected] wrote:Hello All,I recently assembled and mounted M2 LEO-Pack antenna system. Problem: The 2 meter SWR was impacted significantly "after" the antenna was mounted to the boom and phasing lines, coax, and peripheral wiring was secured. (The 70 centimeter side was not impacted.)I'm confident that adjustments to the shorting bars will bring the antenna back into resonance. Question: What's the best way to make the adjustments and perform the tests? Obviously I have both horizontal and vertical entities to adjust. Is there a sequence that I should follow? Any input is greatly appreciated. Warm wishes for a safe and healthy holiday season. Kind Regards best 73sMark Morris N3NJ -----------------------------------------------------------Sent via AMSAT-BB(a)amsat.org. AMSAT-NA makes this open forum availableto all interested persons worldwide without requiring membership. Opinions expressedare solely those of the author, and do not reflect the official views of AMSAT-NA. Acceptable Use and Privacy Policies available at https://www.amsat.org/about-amsat/View archives of this mailing list athttps://mailman.amsat.org/hyperkitty/list/[email protected] unsubscribe send an email to amsat-bb-leave(a)amsat.orgManage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org