AMSAT-BB February 2020

[email protected]

115 participants
190 discussions

Start a nNew thread

cube sat model
by Bob- W7LRD 07 May '21

07 May '21

Hi All-Is there a cube sat model, mock up etc, available anywhere 73 Bob W7LRD

8 7

Re: [amsat-bb] ERC-m g5500 pcsat32
by Pete (vk2pet) 19 Jul '20

19 Jul '20

Hi everyone, Does anyone have the setup details for PCSAT32, integrating with USB ERC-M with G 5500 rotator? I'm after a step by step setup instructions for it please. Running an IC9100 via usb. 73 Pete vk2pet

3 4

AMSAT: RFI from LED bulbs?
by Robert Bruninga 19 Jul '20

19 Jul '20

I am hearing reports of RFI from these LED bulbs. Not just HF, but also VHF. If you can make any quantitative assessments of such RFI, please let me know. And the amazing thing is that at VHF you will never notice it because RFI is noise power and it is noise power that keeps a squelch CLOSED. Manuallly open the squelch and sometimes RFI will show full scale on the S meter yet not open the squelch. And on my radios, when the squelch is closed, the S meter is inactive and shows 0. Bob Bruninga, WB4APR

3 3

Husky-1 Xmit Power
by Mike Lucas 01 Mar '20

01 Mar '20

I've been struggling to get telem downloads the past couple of days.I was hoping to get at least a frame or two to see what the Xmit Power is at. Is it back to low power level again? Mike N7ASZ

6 8

Re: [amsat-bb] Gulf Alpha Antenna Manual
by Gary 29 Feb '20

29 Feb '20

Congrats on the Gulf-Alpha. I had one and loved it. Built battleship strong, computer optimized, using a Tee-match. Nothing flimsy about it! The only thing I did stupid was sell it when I had to move. If anyone wants to part with one, let me know! 73, Joe kk0sd -----Original Message----- From: AMSAT-BB <amsat-bb-bounces(a)amsat.org> On Behalf Of Gregory Beat via AMSAT-BB Sent: Saturday, February 29, 2020 9:47 AM To: AMSAT-BB(a)amsat.org; nachif(a)terra.com.br Subject: Re: [amsat-bb] Gulf Alpha Antenna Manual In November 2015, Tim Chapman, KB7MDF owner of Arrow Antennas purchased the VHF, UHF and Satellite product lines from Pete, owner of Gulf Alpha Antennas. http://www.arrowantennas.com/ga.html Arrow Antennas may have kept (or posted) documentation for those earlier Gulf Alpha Antennas. http://www.arrowantennas.com/ greg, w9gb == Assembly and Tuning Procedures for 2 meter – 70 Cm Dual band Circular Polarized Satellite Yagi 1. Unpack and separate all parts, UHF, VHF element rods, retaining nuts for the element rods, T matches etc. 2. Assemble the two boom sections, be certain to match up the V half’s which are on the ends of each boom section. Usually this is the only way they can go together. Sections are marked VHF, UHF. 3. Mount the T matches this way: on the 2-meter end the feed point connectors go towards the front of the antenna. On the UHF part, the forward T match is mounted with the feedpoint connectors towards the front of the antenna, the rear T match has its feed point connector towards the rear of the antenna (see pics on our website) 4. Mount the element rods. The longest rod is the reflector, the Driven Element is the ¼" dia. The element rods mount in descending order of length with the reflector being the longest, Install the nuts as you go. Just snug them, do not apply a lot of torque as it is not necessary. Use wrenches if necessary but just snug them only. 5. Slide the shorting bars onto the T match rods and driven elements. Set the distances as follows for lowest SWR: 2 Meter part: 3 ¼" 70CM part: All the way out (this is the setting for other brands of UHF antennas as well) The above distances are measured from the inside face of the shorting bars to the end of the T matchbox, not the end of the black bushing. 6. Install the boom to mast plate just behind the last 2-meter element and in front of the second 2-meter T match. Can hold the antenna at a 15 degree angle (recommended if you do not have and elevation rotor). The V clamps V parts butt against the mast. 7. Install the phasing cables. We recommend looking at the pictures on our website to see how they install. Be certain to deep any cables away from element rods, as that will detune the antennas. Never allow a cable to run parallel to an element rod. == Date: Fri, 28 Feb 20 21:32:01 +0000 From: Luciano Gasparini <nachif(a)terra.com.br> To: AMSAT-NA BB <amsat-bb(a)amsat.org> Subject: [amsat-bb] Gulf Alpha Antenna Manual Some years ago I bought a Gulf Alpha 2m/70cm antenna from the factory. I never had the proper location to assemble it until recently. Unfortunately, I cannot find the manual for the above. Could someone help me, please? 73, Luciano PT9KK _______________________________________________ Sent via AMSAT-BB(a)amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb

1 0

SatPC32 difficultly switching to CW
by Tom Schaefer 29 Feb '20

29 Feb '20

I am using SatPC32 on my 9700 with version 12.8d. When I click on the CW- option on screen to switch to CW, the radio does not change. Instead, the title of the window changes to 1524 1504. I thought I saw mention of a patch after revision d but the website indicates no patches. I do have a CW entry in the DOPPLER.SQF file. This happened for different satellites all with a CW entry. Thanks Tom NY4I Principal Solutions Architect Better Software Solutions, Inc. 727-437-2771

2 1

APRS for Android?
by Steve Kristoff 29 Feb '20

29 Feb '20

Does anyone know of an up-to-date APRS app for Android? The original APRSdroid doesn't have very good reviews in the Google app store and apparently hasn't been supported for a couple of years. Steve AI9IN

4 3

FS: Diamond Diplexer for TS2000, FT847, FT736 and other sat rigs
by John Geiger 28 Feb '20

28 Feb '20

I have for sale a Diamond MX-72N which has 1 input (SO239) and splits it into 160-2m on one lead (PL259 plug) and 70cm on the other lead (N male connector). Great for using the Kenwood TS2000, FT847, FT736, Icom 910, etc with 1 dualband antenna. These sell new for $50 plus shipping. I am asking $30 shipped and can take paypal/check/MO.

1 0

Gulf Alpha Antenna Manual
by Luciano Gasparini 28 Feb '20

28 Feb '20

Some years ago I bought a Gulf Alpha 2m/70cm antenna from the factory. I never had the proper location to assemble it until recently. Unfortunately, I cannot find the manual for the above. Could someone help me, please? 73, Luciano PT9KK

2 1

1.2/430 duplexer
by Bob Cutter 28 Feb '20

28 Feb '20

Anyone using one with Alinco handi? 72, Bob KI0G Sent from Yahoo Mail for iPhone

3 2

Jump to page:

2023

2022

2021

2020

2019

2018

2017

2016

2015

2014

2013

2012

2011

2010

2009

2008

2007

2006

AMSAT-BB February 2020